ръководство на потребителя PANASONIC MC-E760

[. . . ] • Do not use with damaged power supply cord or plug. If the vacuum cleaner is not working as it should be, or has been dropped, damaged, left outdoors, or come into contact with water, consult an authorised Panasonic Service Centre. • Do not pull or carry by power supply cord, use power supply cord as a handle, close a door on power supply cord, pull power supply cord around sharp edges or corners. [. . . ] IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE SOCKET OUTLET IN YOUR HOME THEN THE FUSE SHOULD BE REMOVED AND THE PLUG CUT OFF AND DISPOSED OF SAFELY. THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK IF THE CUT OFF PLUG IS INSERTED INTO ANY 13 AMP SOCKET. If a new plug is to be fitted please observe the wiring code as shown below. If in any doubt please consult a qualified electrician. IMPORTANT: The wires in this mains lead are coloured in accordance with the following code: Blue : Neutral Brown : Live As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured BLUE must be connected to the terminal in the plug which is marked with the letter N or coloured BLACK. The wire which is coloured BROWN must be connected to the terminal in the plug which is marked with the letter L or coloured RED. Under no circumstances should either of these wires be connected to the earth terminal of the three pin plug, marked with the letter E or the Earth Symbol How to replace the Fuse: • There are two types of the supplied AC Mains Lead A and B as shown below. 1 Open the fuse compartment with a screwdriver. 2 Replace the fuse and fuse cover if detachable. TYPE A TYPE B This cleaner includes an automatic thermal safety device which automatically turns off the power if the suction inlet, hose or extension wand becomes clogged. If this occurs, disconnect from the mains outlet , remove the material responsible for the clogging and then wait about 40 minutes, before operating your cleaner again. 1) 2) 3) 4) Never let the vacuum cleaner pick up wet matter, mud or burning ashes or materials likely to damage the unit. Before using the vacuum cleaner, remove large or sharp objects from the floor to avoid damaging the machine or the dust bag. Keep the vacuum cleaner away from heat sources such as radiators, fires, direct sunlight, etc. Do not pull on the cord when disconnecting the appliance from the mains, always pull on the plug body itself. This appliance is provided with a power supply cord and if this becomes damaged, it must be repaired by Panasonic, or an Authorised Service Centre or a qualified person in order to avoid any hazard. NOTE: When unpacking the vacuum cleaner, make sure that the accessories in the illustration marked (*), are supplied with the product. (*) A) Hose B-7) Manual suction control (*) A) Telescopic tube a Extension tube b (depending on model) B-5) Crevice nozzle a b B-5) Accessories support (depending on model) b a B-2) Cord rewind pedal D-2) Clean air filter A) Suction inlet B-3) ON/OFF Switch pedal Handle B-4) Floor nozzle selector pedal c d (*) B-4) c d Floor nozzle (depending on model c d ) B-9) Dust bag check indicator (*) D-1) Dust bag D-1) Dust bag compartment B-6) Variable power control (depeding on model) B-5) Dusting brush (depending on model) (*) NOTE: Floor nozzle and tube are subject to change without notice. 1 b 2 1 a B-1) Cord connection B-3) ON/OFF Switch B-2) Automatic cord rewind Start or stop the cleaner, pressing the pedal. Note: Some models attached with a slow start system will take a few seconds to start on the cleaner when pressing the pedal. Rewind the power supply cord, pressing the pedal. B-4) Floor nozzle selector pedal c c Hard floor / Parquet Carpeted floor / Rugs Regulary clean the vacuum cleaner head. B-4) Floor nozzle d d The floor nozzle position has been adapted for cleaning carpeted floors, parquet, hard floors and rung. B-5) Accessories Crevice nozzle Dusting brush (depending on model) B-6) Variable power control (depending on model) B-7) Manual suction control To adjust to the right suction for any cleaning operation. To select the power suction, slide the button to the appropriate position required, depending on your cleaning needs. Closed Opened MIN Curtains Upholstery Cleaning on hard flooring. MAX For more in-grained dirt on carpeted floor. B-8) Park position Located in the top rear side of the vacuum cleaner, there is a convenient clip for parking the floor nozzle during breaks when vacuuming. NOTE: When in the park position, we suggest the appliance is switched off. B-9) Dust bag check indicator NOTE: Check the dust bag condition when the cleaner is at MAX position. The dust bag check indicator is a visual aid to advice you of the condition of the dust bag. [. . . ] 2 IMPORTANT: Never use the cleaner without the correct filters properly installed. Failure to do so may result in motor damaged. Never hold the exhaust cover to carry the cleaner. Re-usable cloth bag Part no. [. . . ]