ръководство на потребителя PANASONIC MC-CL671

[. . . ] • Do not handle plug or vacuum cleaner with wet hands. • Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair and anything that may block or reduce air flow. • Turn off all controls before unplugging. [. . . ] • Do not use the vacuum cleaner without filters and/or dust bag in place. • Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts. • Do not use to pick up flammable or combustible liquids such as gasoline or use in areas where they may be present. • This appliance should be serviced by an authorised Panasonic Service Centre , and only genuine Panasonic spare parts should be used. • Use extra care when cleaning on stairs. Hold the handle of the cleaner in one hand to avoid overturned the vacuum cleaner. NOTE: These vacuum cleaners have been designed for general household use and are not suitable for use in a garage, garden or to suck up liquids. CAUTION FOR AC MAINS LEAD (only UK, IRL) FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY This appliance is supplied with a moulded three pin mains plug for your safety and convenience. Should the fuse need to be replaced please ensure that the replacement fuse has a rating of 13 amps and that it is approved by ASTA or BSI to BS1362. Check for the ASTA mark ASA or the BSI mark on the body of the fuse. If the plug contains a removable fuse cover you must ensure that it is refitted when the fuse is replaced. NOTE: If after having replaced the dust bag, the yellow mark continues appearing in the window, check to see if the hose or suction inlet is clogged. The dust indicator mark, can also appear when using the crevice nozzle. For easy storage, the vacuum cleaner includes a clip system built onto the body of the cleaner, which will keep the extension wand, hose and nozzle in a vertical position. IMPORTANT NOTE: Before servicing any part, always DISCONNECT the cleaner from the electricity supply. D-1) How to replace the dust bag 1) Lift the dust cover up as shown. 2) Push clamp forwards and take out dust bag pulling cardboard up. 3) 4) Insert new dust bag by guiding cardboard into the guide slots and push forwards. Close the dust cover. IMPORTANT: When the dust bag is not in position or it has not been installed correctly, the dust cover will not close. Use only original Panasonic dust bags Type C-20E. Use of non-original dust bags may affect the performance of or damage the unit. D-2) Filter care Central Filter (Fig. AMC8F03D1100 The central filter (foam filter), is installed in the dust bag compartment to protect the motor from dirt. When it becomes dirty, simply rinse it out in warm water and dry it thoroughly before replacing. To remove the central filter, hold the filter at the top (as illustrated) and pull it out. Important: Ensure that the filter is completely dry before re-installing it into the cleaner. Fig. 2) Part no. : AMC8F28T1000 / MC-CL671, MC-E761, MC-E762, MC-E763, MC-E785 AMC8F28T3000 / MC-E783, MC-E787 The clean air filter, is installed in the rear side of the cleaner. This filter retains any small dust particles which may be present in the expelled air. [. . . ] 2) Part no. : AMC8F28T1000 / MC-CL671, MC-E761, MC-E762, MC-E763, MC-E785 AMC8F28T3000 / MC-E783, MC-E787 The clean air filter, is installed in the rear side of the cleaner. This filter retains any small dust particles which may be present in the expelled air. It is advisable to change the clean air filter when it becomes dirty. As a guide, once or twice a year is usually sufficient depending on use. [. . . ]